1425 Thorne Ave

DANA 30 HIGH STEER

**HIGH STEER INSTRUCTIONS**

**Order High Steer Now**

This kit will fit any axle with TJ Style 30 Outers including the Jeep Rubicon Dana 44 and any factory Dana 30 1987 and up

This kit includes 2 new knuckles, hub esentric bearing rings, caliper brackets, sway bar brackets, a trac bar bracket and One Ton tie rod ends and drag link using standard 1.250" DOM tubing. With an option for 1.5" .250'' wall tubing as a heavy duty upgrade.	This picture shows a new knuckle installed on the factory axle using factory ball joints.
This picture shows the alignment dowels installed in the new knuckle.	New hub esentric bearing ring installed waiting for factory wheel bearing assembly and axle to be installed.
Factory hub bearing to be installed using stock hardware.	A brake upgrade is included in the kit utilizing 90' S-10 calipers, pads and caliper bolts.
Highsteer kit installed with the factory steering linkage held in place to show how much ground clearence is gained by installing this kit.	Up to 6'' of lift, reuse your factory pittman arm. 6'' and up use a drop pittman arm with this kit.
	The cost of the Dana 30 Highsteer Kit is $1195.95. To order please click below: HighSteer Kit